2026-04-27T21:22:40Zhttps://uvadoc.uva.es/oai/request

oai:uvadoc.uva.es:10324/769602025-12-03T08:00:34Zcom_10324_35294com_10324_952com_10324_894col_10324_35295

González Martín, Javier Campo, Aránzazu del Muñoz Torre, Raúl Lebrero Fernández, Raquel 2025-07-29T11:23:37Z 2025-07-29T11:23:37Z 2025 Journal of Environmental Chemical Engineering, 2025, vol. 13, n. 4, p. 117324 2213-3437 https://uvadoc.uva.es/handle/10324/76960 10.1016/j.jece.2025.117324 117324 4 Journal of Environmental Chemical Engineering 13 Producción Científica The potential of bioactive coatings as an innovative biotechnology to overcome the mass-transfer limitations of conventional technologies when treating air pollutants, especially hydrophobic volatile organic compounds, was herein assessed. Bioactive coatings consist of active microorganisms entrapped in a polymer matrix, which needs to be porous to facilitate an effective gas pollutant exchange. To increase porosity, two additives, sucrose and glycerol mixtures (Suc/Gly) and halloysite nanotubes (HNTs), were included in the bioactive coatings at two concentration levels. The toluene removals of the different bioactive coatings were studied in batch mode at low (∼300 mg m−3) and high (∼3000 mg m−3) toluene concentrations. Overall, low HNTs concentration coatings supported optimum toluene removals (>95 %), comparable to biofilm controls at both toluene concentrations. High HNTs concentration coatings and low Suc/Gly concentration coatings achieved toluene removals over 95 % after 7 toluene injections at low toluene concentration. At high toluene concentrations, these coatings eventually outperformed the biofilm controls. High Suc/Gly concentration coatings supported a limited toluene removal (4 and 1 injection at low and high toluene concentrations, respectively), attributed to a preferential consumption of sucrose over toluene. These findings were corroborated by ESEM/conventional SEM imaging, revealing porosity in the HNTs bioactive coatings, visible at both the surface and internal levels. On the contrary, more homogeneous surfaces were observed in the Suc/Gly bioactive coatings, where total polymer coalescence was partially hindered by the addition of Suc/Gly. These results paved the way towards the implementation of bioactive coating in larger bioreactors for real-life air purification. Ministerio de Ciencia, Innovación y Universidades [proyecto RTI2018–0–096441-B-I00] Junta de Castilla y León y al programa FEDER de la UE [UIC 393, UIC 379] Junta de Castilla y León (Consejería de Educación) y del Fondo Social Europeo (BDNS 487971): contrato predoctoral de Javier González Martín application/pdf eng Elsevier info:eu-repo/semantics/openAccess http://creativecommons.org/licenses/by-nc-nd/4.0/ © 2025 The Author(s) Attribution-NonCommercial-NoDerivatives 4.0 Internacional Optimizing the composition of bioactive coatings to support toluene removal info:eu-repo/semantics/article info:eu-repo/semantics/publishedVersion https://www.sciencedirect.com/science/article/pii/S2213343725020202 SI 3302 Tecnología Bioquímica