Skip navigation
Por favor, use este identificador para citar o enlazar este ítem: http://uvadoc.uva.es/handle/10324/21856
Título: Effect of sintering cooling rate on corrosion resistance of powder metallurgy austenitic, ferritic and duplex stainless steels sintered in nitrogen
Autor: García Cabezón, Cristina
Martín Pedrosa, Fernando
Blanco, Yolanda
Año del Documento: 2012
Editorial: ELSERVIER
Documento Fuente: Corrosion Science (2012) 61, 45–52
Resumen: Duplex stainless steels obtained by powder metallurgy from austenitic AISI 316L and ferritic AISI 430L powders were studied. Austenitic stainless steel and ferritic stainless steel were also obtained for comparative purposes. All materials were sintered in nitrogen with three sintering cooling rates: furnace, gas and water. Corrosion resistance using anodic polarization measurements and electrochemical potentiodynamic reactivation tests were evaluated. The cooling rate was a determinant factor. For the duplex and ferritic stainless steels, a beneficial effect on the anodic behaviour and the degree of sensitization for water cooled materials was observed. Gas cooling was preferred for austenitic stainless steel.
Materias (normalizadas): Stainless steel
Polarization
Intergranular corrosion
Passivity
ISSN: 0010-938X
Revisión por Pares: SI
DOI: http://uvadoc.uva.es/handle/10324/21844
Patrocinador: Ministerio de Ciencia e Innovación, Dirección General de Programas y Transferencia de Conocimiento, Proyectos I+D, MAT2008-02788
Propietario de los Derechos: ELSERVIER
Idioma: eng
URI: http://uvadoc.uva.es/handle/10324/21856
Derechos: info:eu-repo/semantics/embargoedAccess
Embargado hasta2030-01-01
Aparece en las colecciones:DEP07 - Artículos de revista

Ficheros en este ítem:
Fichero Descripción TamañoFormato 
Corrosion Science 61(2012) 45-52.pdf1,05 MBAdobe PDFVisualizar/Abrir


Los ítems de UVaDOC están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.

Comentarios
Universidad de Valladolid
Powered by MIT's. DSpace software, Version 5.5