Skip navigation
Por favor, use este identificador para citar o enlazar este ítem: http://uvadoc.uva.es/handle/10324/23435
Título: Titanium dioxide nanoparticle coating in fluidized bed via supercritical anti-solvent process (SAS)
Autor: Martín, Víctor
Romero Diez, Rut
Rodríguez Rojo, Soraya
Cocero Alonso, María José
Año del Documento: 2015
Editorial: Elsevier
Documento Fuente: Chemical Engineering Journal, 2015, vol. 279, p.425–432
Resumen: A process to coat nanoparticle agglomerates has been developed and its critical operation parameters have been studied in this work. It consists on a fluidized bed where a supercritical anti-solvent process (SAS) takes place. Titanium dioxide (TiO2), used as model nanoparticle, has been coated with a polymer, Pluronic F-127, from an ethanolic solution. As main factors that can affect the coating process, the following process parameters were studied: the ratio between the velocity of carbon dioxide through the bed and the minimum fluidization velocity (umf), with values from 1.5 to 2.5 times the umf; the density of carbon dioxide, varying from 640 kg/m3 to 735 kg/m3 approximately; the flow rate of solution, within an interval between 0.5-2 mL/min; the concentration of the solution, from 0.030 mg/mL to 0.090 mg/mL and the mass ratio polymer-particle, 0.45-1.8 g/g. The process parameters were selected taking into account the values that increased the yield, defined as gram of coating material per gram of introduced polymer amount, and maintained a unimodal particle size distribution (PSD), with low increment in the mean particle size with respect to raw TiO2. All the samples were analyzed by four different methods, which showed the successful results of the experiments. The yield was analyzed gravimetrically, and the PSD was determined by laser diffraction. The presence of polymer on the surface of the nanoparticle agglomerates was verified by FT-IR spectrum and fluorescence microscopy, which also showed the quality and uniformity of the coating. Furthermore, the bulk density of the samples was measured showing a lineal variation with the mass ratio polymer-particle.
Revisión por Pares: SI
DOI: https://doi.org/10.1016/j.cej.2015.05.014
Patrocinador: info:eu-repo/grantAgreement/EC/FP7/280983
Patrocinador: This work is partially supported by the project Shyman FP7-NMP-2011-LARGE-280983 and the project CTQ2013-44143-R of the Spanish Ministerio de Economía y Competitividad. Víctor Martín thanks the University of Valladolid for his doctoral grant. Rut Romero-Díez would like to thanks her agreement with the University of Valladolid. Soraya Rodríguez-Rojo thanks the Spanish Ministerio de Ciencia e Innovación and the University of Valladolid for her Juan de la Cierva fellowship (JCI-2012-14992).
Idioma: eng
URI: http://uvadoc.uva.es/handle/10324/23435
Derechos: info:eu-repo/semantics/embargoedAccess
Aparece en las colecciones:Documentos OpenAire(Open Access Infrastructure for Research in Europe)
DEP48 - Artículos de revista

Ficheros en este ítem:
Fichero Descripción TamañoFormato 
Articulo_Rev_final.pdf747,28 kBAdobe PDFThumbnail
Visualizar/Abrir


Los ítems de UVaDOC están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.

Comentarios
Universidad de Valladolid
Powered by MIT's. DSpace software, Version 5.5